Cautions for the operation of the Cross Cutting Machine

Prevent damage

When the Cross Cutting Machine is running, you should pay attention to whether there are people or other objects in front to avoid collision.

After each cut, the cutting torch should be raised to the highest point to avoid hitting the steel plate and damaging the cutting torch.

Mechanical maintenance personnel should ensure that the machine is stopped during maintenance. And put up a warning sign to avoid accidents caused by sudden operation of the machine.

When the machine is running for a long time, do not directly touch the heat sink and other heating components on the module with your hands to avoid burns.

Operation precautions

Before starting the cross cutting machine, check whether there is any air leakage in the pipeline of the machine. Never start the machine if there is air leakage.

After starting the machine, check whether there are obstacles on the working surface and guide rails. If there are obstacles, they must be removed.

Operators are not allowed to leave their posts at will, and non-operators are not allowed to start the machine at will.

In the event of an emergency during operation, immediately press the red emergency stop switch to prevent accidents.

Pay attention to the command and coordination of special administrators when repairing and maintaining CNC.

Before shutting down, close all air valves and release the remaining air in the air circuit.

If there is flashback in the pipeline, immediately cut off the power and gas. There must be a record of the malfunction of the machine.

If a fault is found, there shall be a fault record.